Harness and equipment inspection.

We check, tag and record your height safety gear to AS/NZS 1891.4, so your team can get on the roof.

StandardAS/NZS 1891.4 and the manufacturer's instructions
IntervalWhichever of the two is shorter
On top of thatA pre-use check by the person using it
OutputA register per item, a certificate, a tag on each
ScopeHarnesses, lanyards, connectors, descenders, rope, slings, helmets
WhereAt your site or depot, or bring it to us
QuoteThe site visit and the written quote are free
CoverageAuckland based, working New Zealand wide
On Ropes technician rigging ropes from a rooftop before a drop

Gear wears out where you cannot see it.

Height safety gear wears out in ways you cannot see. Sunlight weakens webbing. Grit works into rope and cuts it from the inside. One shock load can retire an item that still looks new.

AS/NZS 1891.4 says gear must be checked by a competent person at set intervals. That sits on top of the check the user does before every job. Without current records, a main contractor can turn your people away.

On Ropes technician demonstrating rope-access technique at the National Safety Show 2026

Equipment we inspect and tag.

Ten kinds of gear we check. If yours is not here, ring and ask.

01
Full body harnesses and work belts
02
Lanyards, energy absorbers and rope grabs
03
Connectors, karabiners and scaffold hooks
04
Descenders, ascenders and back-up devices
05
Kernmantel rope and rope protectors
06
Anchor straps, slings and temporary anchors
07
Inertia reels and fall-arrest blocks
08
Helmets and head protection
09
Rescue and recovery kits
10
Portable and temporary anchorage

How an inspection runs.

Four steps, whether it is one harness or a full store room.

  1. 01

    Book it in

    We come to your site or depot, or you bring the gear to us.

  2. 02

    Item by item

    Each item is checked against its own manufacturer's instructions and logged by serial number.

  3. 03

    Tag and register

    Every item that passes gets a tag with the date done and the date due.

  4. 04

    Withdrawal list

    Anything that fails is tagged out of service and listed with the reason.

Rigging off the roof anchors at first lightSite footage · 0:25

Quick questions.

What safety managers ask before booking us. More on the full FAQ page.

How often does our gear have to be inspected?

The interval comes from AS/NZS 1891.4 and from the manufacturer's instructions, and the shorter of the two applies. That sits on top of the check the user does before every use.

Can you inspect gear you did not supply?

Yes, and most of what we check is not ours. We work to the manufacturer's instructions, so those have to be available. Gear with no manufacturer, serial number or instructions cannot be certified.

What happens to gear that fails?

It is tagged out of service and listed with the reason. If you ask, we will destroy it, so it cannot find its way back into a kit bag.

We are not a rope access company. Can you still help?

Yes. A lot of this work is for building and facility teams, roofers, cladders and other trades whose people go up now and then.

What do we get at the end?

A register listing every item, its serial number, the date done and the date due. Plus a certificate, and a tag on each item.

Tell us about your building.

Send the address and what you are seeing. We will come and look, then send a clear, itemised quote.